H-8501ABExclusively designed for bonding extrusion type peroxide cured silicone rubber gaskets ,clear transparent appearance which swiftly cures to be silicone polymer in high temperature environment ,offering permanent bond of the silicone rubber joint cord.
Mix viscosity(25℃)，mΡa.s: 50000
Specific Gravity(g/cm³): 1.10
Operable time(25℃),h: 4.0
Curing time（80℃）,min.: 30-60
Tensile strength(Mpa): 4.0
ardness(Shores A): 35±5
Adhesive property: ≥2.0(A1-A1,cohesive failure )
Volume resistance(Ω • cm): 1×10
Dielectric strength(KV/mm): 20
1.Spread the adhesive on a thin sheet, coating thickness less than 0.5mm(evenly distribute the adhesive to ensure dipping amount the same )
2.Preheat the rubber cords against the hot mold less than 4 seconds
3.Dip both sides of silicone gaskets ends with tiny bit of adhesives from the sheets
4.Swiftly push in the two the cord joints by your hands (make sure the adhesive not get cured before the two cord end meets ),keep the horizonal pressure until the upper mold close down to secure full contact of the bonding area.
5.Close the mold for 8-10seconds with temperature 175-180 degrees, enabling the adhesive to deliver optimized bonding strength after absorbing sufficient heat.